Optimum Optimill MT 50, Руководство по эксплуатации

Страница: 9 / 91

Version 1.2.8 - 2020-08-03 9 Translation of original operating manual
MT50 GB
MT
5
0_GB
_1.
fm
If the milling-machine is used in any way other than described above, modified without the
approval of the company Optimum Maschinen Germany GmbH then the milling-machine is
being used improperly. We will not be held liable for any damages resulting from any operation
which is not in accordance with the intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company Optimum
Maschinen Germany GmbH.
It is also part of intended use that you

the maximum values for the milling-machine are complied with,

the operating manual is observed,

the inspection and maintenance instructions are observed.

Technical data on page 19
WARNING!
Heaviest injuries through improper use.
It is forbidden to make any modifications or alternations to the operation values of the
milling-machine. They could endanger the personnel and cause damage to the milling-
machine.
1.4 Reasonably foreseeable misuses
Any other use as the one determined under the "Intended use" or any use
beyond the described use shall be deemed as not in conformity and is forbidden.
Any other use has to be discussed with the manufacturer.
It is only allowed to process metal, cold and non-inflammable materials with the milling-
machine.
In order to avoid misuses it is necessary to read and understand the operating instructions
before the first commissioning.
The operators must be qualified.
1.4.1 Avoiding misuses

Use of suitable cutting tools.

Adapting the speed adjustment and feed to the material and workpiece.

Clamp workpieces firmly and vibration-free.
ATTENTION!
The workpiece is always to be fixed by a machine vice, jaw chuck or by another
appropriate clamping tool such as for the clamping claws.
WARNING!
Risk of injury caused by workpieces flying off.

Clamp the workpiece in the machine vice. Make sure that the workpiece is firmly clamped in
the machine vice resp. that the machine vice is firmly clamped on the machine table.

Use cooling and lubricating agents to increase the durability of the tool and to improve the
surface quality.

Clamp the cutting tools and workpieces on clean clamping surfaces.

Sufficiently lubricate the machine.

Correctly adjust the bearing clearance and the guidings.
It is recommended:

Insert the drill in a way that it is exactly positioned between the three clamping jaws of the
quick action chuck.