Version 1.2.8 - 2020-08-03
47
Translation of original operating manual
MT50
GB
MT
5
0_GB
_5.
fm
6
Maintenance
Properly-performed regular maintenance, cleaning and repair is an essential prerequisite for
safe operation, fault-free operation, a long service life of the multifunctional drilling-milling
machine and the quality of the products manufactured with it.
6.1
Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
Very serious injury to personnel working on the milling-machine,
damage to the milling-machine.
Only qualified staff should carry out maintenance and repair work on the milling-
machine.
6.1.1
Measures before repair works
Switch off the machine according to these operating instructions and secure it against unex-
pected switching on again.
Disconnect the machine from the power supply.
6.1.2
Notes for repair
Observe maintenance dates and activities which are prescribed in the operating instruc-
tions.
Observe the procedures of switching on and off which are described in the operating
instructions.
A shop equipment suitable for performing repair measures is required.
6.1.3
Measures before switching on again and after repair measures
Before restarting run a safety check.
There must be no dangers for persons.
The milling-machine must not be damaged.
6.2
Cleaning
WARNING!
Only perform cleaning works when the machine is switched off.
Do not use petrol, thinner or compressed air for cleaning tasks.
CAUTION!
Biological and Microbiological hazards in the coolant circuit. Wear protective gloves
when the coolant is changed.
At the end of each day's work, remove the workpiece and the clamping gear and clean the
table.
For rough cleaning tasks use a chip hook, a hand brush, vacuum cleaner or slot cleaner.
Remove solings and remaining lubricants with kerosene or special cleaning agents.
afterwards lightly lubricate blank surfaces.
