OPTIMUM
M A S C H I N E N - G E R M A N Y
Unpacking and connecting
©
201
0
US
Page 21
Stand 27 / 08 / 2010
Version 1.0.6
BF 30 Vario
Mill Drill
ATTENTION!
Insufficient rigidity of the foundation leads to the superposition of vibrations between the
mill drill and the foundation (natural frequency of components). Insufficient rigidity of the
entire milling machine assembly also rapidly causes the machine to reach critical
speeds, with unpleasant vibrations, leading to bad milling results.
Position the mill drill on the intended foundation.
Attach the mill drill using the provided recesses in the machine base.
WARNING!
The quality of the stand and the kind of fixture of the machine stand to the substructure
has to assimilate the loads of the machine. The substructure needs to be even. Please
check the horizontal alignment of the substructure of the machine with a level. Fix the
machine to the substructure at the provided recesses at the stand. Connector cartridges
or heavy-duty bolts are strongly recommended.
„Installation plan“ on page 16,
„Installation plan of optional stand“ on page 17.
3.5
First use
WARNING!
Risk by using improper workpiece clamping materials or by operating the machine with
inadmissible speed.
Only use the clamping materials (e.g. drill chuck) which had been delivered together with
the machine or as optional equipment.
Use the working clamping materials only in the provided admissible speed range.
Workpiece clamping materials must only be modified according to the recommendations
or of the clamping material manufacturer.
WARNING!
Staff and equipment may be endanged if the mill drill is first used by inexperienced staff.
We do not take responsibility for damage caused by incorrect commissioning.
„Qualification of personnel“ on page 8
3.5.1
Power supply
Connect the electrical supply cable.
Check the fuse protection (fuse) of your electrical supply according to the technical specifica-
tions for the total connected load of the mill drill.
3.5.2
Cleaning and lubricating
Remove the anti-corrosive agent applied to the mill drill for transport and storage purposes.
We recommend the use of mineral spirits with a soft cloth.
Do not use any solvents, thinners or other cleaning agents which could corrode the varnish
on the mill drill. Follow the specifications and indications of the manufacturer of the cleaning
agent.
Lubricate all bright machine parts with non-corrosive lubricating oil.
Grease the mill drill using the lubrication chart.
„Inspection and maintenance“ on page 33
