Operation
Version 1.4.3 - 2020-12-14
24
Translation of original instruction
BF16V
EN
BF16V_
G
B_
4.f
m
4.2
Safety
Commission the drilling-milling machine only under the following conditions:
The drilling-milling machine is in proper working order.
The drilling-milling machine is used as intended.
The operating manual is followed.
All safety devices are installed and activated.
All failures should be eliminated immediately. Stop the drilling-milling machine immediately in
the event of any abnormality in operation and make sure it cannot be started up accidentally or
without authorisation.
For your own safety during operation on page 13
4.3
Switching on the drilling-milling machine
By pressing the green button, the
machine is switched on.
By pressing the red button, the machine
is switched off.
Fig.4-1:
Control panel
The electronics controls the speed slowly to the target value with a ramp. Therefore, please
wait a while before you continue milling or drilling with the feed.
4.4
Inserting a tool
The mill head is equipped with an MT 2 seat and a draw-in rod M10.
ATTENTION!
When installing a cold morse taper into a heated-up machine those MT seats tend to
shrink on the morse taper contrary to the quick-releaser tapers.
When installing a cold Morse taper in a heat spindle sleeve fix the draw-in rod only hand
tight and after a temperature equilibration about 3 - 5 minutes later accordingly stronger.
INFORMATION
This Morse taper holder was intended chosen for your machine, that tools that are normally
used on drills also can be used for your machine. Reducing or adapters are not allowed on mil-
ling machines.
CAUTION!
When milling operations are performed the cone seat must always be fixed to the draw-
in rod. All cone connections with the taper bore of the work spindle without using the
draw-in rod is not allowed for milling operations. The cone connection should be
released by the lateral pressure. Injuries may be caused by parts flying off.
In the work spindle you may only use tool holding fixtures and clamping tools with
Morse taper MT2 and internal screw thread M10 for an interlocking fixture. Reducing
bushes is not allowed.
Switch "ON"
Switch "OFF"
Potentiometer
speed adjustment
