Oprema Juice Premix-Postmix, Инструкция по установке и обслуживанию

Страница: 29 / 36

29
EN
DESRIPTION AND INSTALLATION
The water pressure is factory set to 2 bar, which is the correct
operating temperature pressure. Check by pressing and holding
the key and reading the pressure on the water regulator. If there
is a variation, set it by turning until you get 2 bar pressure. (Do
not forget to put the glass under the tap before checking.)
Put the bag in box and connect it to the electro magnetic valve
and vent it. The tube is positioned so that it is placed in the
center of the electro magnetic valve and tubes. Cut the hose to
the correct length and put it in the elbow ejector connection.
Place the glass under the outlet pipe - tap. Fill the glass of
juice by pressing the product button. Make sure the brix
ejector (mixing ratio) is correct position, if not, set it up. Brix
adjustment is done by turning the adjusting screw on the
ejector. Follow the label on the opening to increase /
decrease the ejector brix. After setting the brix, the device is
ready for use.
The device user receives a key for basic use, ie setup and modification syrups and cleaning
and maintaining the refrigeration chamber.
The responsible person / servicer uses the ”program key” to set the parameters of the
dispensing, and cleaning and sanitation.