Working with Jobs
89
Operator Manual
OPEX Corporation
4.15. ID Assist
When configured in a Job and per Page Type, ID Assist provides an additional
method for identifying and/or applying an action to item being scanned. ID
Assist does not work in Stack Feed mode.
ID Assist uses three through-beam sensors: ID Assist Verify and ID Assist #1
are used together to trigger the ID Assist feature. ID Assist #2 is used for
tracking items that have been placed on the conveyor after triggering ID Assist.
4.15.1. Using ID Assist
To trigger ID Assist, swipe the item left to right in front of the ID Assist verify
and ID Assist #1 sensors (Figure 4-24) and release the item on the conveyor.
The ID Assist verify sensor puts the ID Assist feature in an enabled state
pending the item continuing to the right, blocking ID Assist #1. If the item is not
fully swiped to the right, ID Assist will not be triggered.
When a Job is run that uses ID Assist, the ID Assist indicator LED will be lit.
When ID Assist is triggered, the indicator light will blink, indicating that ID
Assist was triggered. Once the item is scanned, the ID Assist LED will turn off.
Содержание Falcon+
