OPERATION
18 / 56
X700-3000_usermanual_engl_20170405.docx
(switch to standby or bypass mode,
depending on the menu setting)
Selection
In configuration mode: Press the but-
ton to apply the selection
SELECT /
Switch over
In normal mode: Switching the dis-
play from input voltage, frequency
and current, battery voltage, current
and capacity, UPS internal tempera-
ture, output voltage, frequency and
current, load
Configuration mode
In standby mode: Press button for
longer than 2 seconds to start config-
uration mode
Down
In configuration mode: Back to menu
ON
+ SELECT
Manual
bypass mode
In normal mode: Press both buttons
for longer than 2 seconds to switch to
bypass mode. (Depending on the in-
put voltage). In order to exit bypass
mode / switch back to normal mode,
press both buttons at once until the
permanent beeping stops. Not avail-
able in frequency converter mode.
Exit
In configuration mode: Press both
buttons to revert from the sub-menu
to the main menu or, if you are in the
main menu, to exit configuration
mode immediately.
Table 2: Descriptions of display
PLEASE NOTE
During the function of battery test, the batteries must be com-
pletely charged and the UPS system must be in normal mode.