Oneida Air Systems Supercell XSK000014, Руководство пользователя

Страница: 17 / 32

oneida-air.com 15
Assembly Instructions (Continued)
Pulse Bar
FIG. 20
FIG. 19
G18
G2
A
A
19
Install the Barrel Gasket (G2) onto the
rounded, bottom edge of the Motor Assembly
(A). The Barrel Gasket (G2) should be oriented
so that the "ribbed" side is facing downwards
[FIG. 19].
20
Attach one end of the Vinyl Tubing (G18) onto
the hose fitting located underneath the Motor
Assembly's (A) plastic cowl. The fitting will
be on the side opposite to the pulse bar. Push
the hose onto the fitting so that all of barbs are
covered [FIG. 20].
Note: The Motor Assembly's (A) plastic cowling
can be temporarily removed for easier access
to this fitting during installation. Lift the
foam placed at the top of the cowl to access
the retaining nut. Replace the foam and the
hardware when you have finished attaching
the Vinyl Tubing ( G18 ). Refer to Maintenance
section as shown on page 24.
DO NOT TURN ON OR PLUG IN YOUR DUST COLLECTOR UNTIL INSTALLATION IS COMPLETED.
NEVER RUN THE SYSTEM WITHOUT THE MOTOR COWLING IN PLACE.