Oneida Air Systems Supercell XSK000014, Руководство пользователя

Страница: 12 / 32

Oneida Air Systems, Inc. 10
16"
406 mm
4"
89 mm
1/2"
13 mm
Assembly Instructions (Continued)
6
Using appropriate fasteners for the wall type
you are installing your system onto, drill into
and install fasteners into the wall at all marked
locations [FIG. 6].
a. Maximum Fastener Size: 5/16" diameter
for the 4 keyholes
b. Maximum Fastener Size: #12 screw for the
rear support brace holes
c. Maximum Washer Size: 3/4" outside
diameter
7
Place washers onto each fastener and thread
the fasteners into all four holes, leaving at least
1/2" outside of the hole to fit the Wall Bracket
(F) and Rear Support Brace (G13) [FIG. 7].
FIG. 6
FIG. 7
W
all
5
Place a mark through the Template's (G1)
paper at each indicated crosshair (four keyway
holes and one center hole), then remove the
Template (G1) from the wall [FIG. 5a].
Measure 15-1/4" straight up from the center
hole mark and mark a straight level line to
help with the install of the Rear Support Brace
(G13) [FIG. 5b].
Mark
Here
Mark
Here
FIG. 5a
FIG. 5b