Omron V530-R2000, Руководство пользователя

Страница: 58 / 153

41
V530-R2000
User’s Manual
SECTION 5
Se
tt
in
g the
Commun
ic
a
tions
M
ode
SECTION 5
System Settings
Host Link Communications
l
System Set./Com Mode
1.
Make the settings for each item.
2.
Select OK .
Item Selections Description
Com Mode Normal (default), Host Link Select Host Link to communicate in Host Link for-
mat.
Interface RS-232C (default),
RS-422
Set the data transfer method used to connect the
Controller and host.
Read Area I/O (I/O bits) (default)
HR (holding bits)
LR (link bits)
DM (Data Memory)
None (Reading not performed.
TXD instruction accepted.)
Select the area used by the Controller to check for
commands.
Begin Read Word 0 to 9995
(default: 0) Set the word to start reading from.
Write Area I/O (I/O bits) (default)
HR (holding bits)
LR (link bits)
DM (Data Memory)
None (Writing not performed.)
Select the area used by the Controller to output exe-
cution results.
Begin Write Word 0 to 9996
(default: 100) Set the word to start writing from.
PLC Mode Check ON (default), OFF If PLC Mode Check is set to ON , the PLC’s mode
will be checked during reading.
Reading will not be performed if the PLC is not in
MONITOR mode. (An error message is displayed.)
If PLC Mode Check is set to OFF , a command will
be sent to the PLC to force it to change to MONITOR
mode when the Read Screen is entered.
Com Mode
Interface : RS-232C
Read Area : I/O
Begin Read Word : [ 0]
Write Area
: I/O
Begin Write Word : [ 100]
PLC Mode Check : ON
Cancel OK
Com Mode : Host Link