Omron SYSMAC-SE2, Руководство по практике

Страница: 46 / 54

Six-port Junction Slaves

PLC Box
Set the PLC box as follows.
ID Property name Setting value
20161 Configuration project Same value as "Configuration project" of the CPU Unit
20408 Station ID Any name in a format that meets the EPLAN specification con-
straints and is different from "Station ID" of other component
data
20253 1 CPU: Name [1] Same value as "CPU: Name [1]" of the CPU Unit
20418 Version Revision of the EtherCAT slave (This must be a version that
exists in the Sysmac Studio and a single-byte number that con-
tains periods as the delimiter.)
If blank, the component data will be imported with the latest
version.

Bus Ports (EtherCAT Ports)
Set the EtherCAT ports as follows.
ID Property name Setting value
20311 Physical network: Bus ID /
item number (a): Node address on the input, X2, or X3 side (Set a single-
byte number within the node address range of the CPU Unit
that can be set.)
(b): Node address on the X4, X5, or X6 side (Set a single-byte
number within the node address range of the CPU Unit that
can be set.)
(a)
(b)
GX-JC06
Precautions for Correct Use
To import EtherCAT slaves, you need to set this as follows.
• Place the EtherCAT slaves in the Schematic single-line page.
• Set the node addresses so that they do not conflict with other slaves.
3-3-3
NX Units
Set the component data for NX Units as follows.
3 Setting EPLAN Electric P8
3-10
Sysmac Studio Electrical CAD Connector Function Practices Guide for AutomationML Import (EPLAN Electric P8) (P156)