Omron SYSMAC CXONE-ALC-EV2 Series, Руководство по эксплуатации

Страница: 16 / 55

xvii
Application Precautions
4
For 3G3MV-series Inverters: The CS1W-CIF31 cannot be used. Use the com-
mercially available products listed below.
Commercially Available USB-Serial Conversion Cables
BHS-US01/GP manufactured by Buffalo
USB-CVRS9 manufactured by Sanwa
The commercially available USB-serial converters have been successfully
tested for OMRON Inverters but operation may be unstable in some operating
environments (mainly depending on the ambient temperature, humidity, and
noise). The functions, performance, and reliability of these converters may not
be as specified under all possible conditions. Check the warranty information
from the manufacturer.
4 Application Precautions
Observe the following precautions when using the CX-Drive.
• Confirm that set parameters operate properly before using them in actual
applications.
• Do not turn OFF the power to the Servo Drive while writing to flash mem-
ory. In the worst case, doing so may damage the flash memory.
• After replacing an Inverter or Servo Drive, restart operation only after sav-
ing the required parameters in the new Inverter or Servo Drive.
• Confirm that no adverse effect will occur in the system before attempting
any of the following. Not doing so may result in an unexpected operation.
• Changing the operating mode of the PLC (including changing the Star-
tup Mode)
• Changing parameter settings
• Automatically downloading parameters (This function is enable by se-
lecting the Autodownload when a parameter is updated Option on the
Online Options Tab Page in the window that appears when Tools - Op-
tions is selected from the menu bar.)
• Do not turn OFF the power to the computer while installing or uninstalling
the CX-Drive. Doing so may result in corrupted data in the computer.
• The multi-turn counter and alarms will be set in the absolute serial
encoder if the absolute encoder setting function is performed. If the abso-
lute encoder’s multi-turn counter is reset to zero, the coordinate system of
the mechanical system will change from what it was previously. Be sure
that the encoder is set correctly before resetting the mechanical system to
the zero point.