![background image](http://html1.mh-extra.com/html/omron/omnuc-r88d-uep-series/omnuc-r88d-uep-series_user-manual_744167097.webp)
4-4
j
Changing the Mode
Use the MODE/SET Key to change from one mode to another.
. b
b
c
n
0
0
u
n
0
0
0
a.0
2
Power ON
Status display
mode
Settings mode
Monitor mode
Alarm history
display mode
(Display example)
4-1-2 Status Display Mode
The status display mode is entered when powering up or by means of the MODE/SET Key. In the status
display mode, Servo Driver status is displayed in two ways: bit data and symbols. These displays are
shown in the following illustration.
b b
Rotation detected/Current limit detected
Positioning completed
Command pulse input
Base block
Power supply ON
Bit data display
Symbol display
j
Bit Data Display Contents
Bit data
Contents
Power supply ON
Lit when Servo Driver power supply is ON.
Base block
Lit during base block (no power to motor); dimmed when servo is ON.
Positioning completed
Lit when the pulse count remaining on the deviation counter is equal to or less
than the positioning completed range set in Cn-1b.
Rotation detection
Lit when the motor rotational speed is 20 r/min or higher.
Command pulse input
Lit when the specified command pulse is being input.
j
Symbol Display Contents
Symbol display
Contents
bb
Base block (no power to motor)
rUn
Operating
p%t
Forward rotation prohibited
n%t
Reverse rotation prohibited
a
.
Alarm display (Refer to alarm table.)
Application
Chapter 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com