"The Right Control for Your Application."
12095 NW 39 Street, Coral Springs, FL 33065-2516
Telephone:
954-346-4900;
Fax:
954-346-3377
KB
Electronics,
Inc.
www.kbelectronics.com
KBBC SERIES OPERATING INSTRUCTIONS
(A40140) – Rev. A00 – 6/10/2014
Page 1 of 4
FIGURE 1
CONTROL LAYOUT AND GENERAL CONNECTION DIAGRAM
P5
P1
Notes: 1.
If Key Switch is not used, a connection must be made between the red wire of Connector P1 (Terminal 3) and quick-connect
Terminal B+ for the control to operate.
2.
To reset the control in wig-wag mode, return the Main Speed Potentiometer to the center position.
3.
Run Forward and Run Reverse Switches are not used in wig-wag operation.
4.
If wiring a fuse or circuit breaker, it must be wired in the
location shown, immediately after the battery positive (+) terminal. The Key Switch must be wired after the fuse or circuit breaker.
FIGURE 2
DESCRIPTION AND WIRING OF CONNECTORS
