Omron NT20M series, Руководство по эксплуатации

Страница: 39 / 86

33
3. Perform the transfer operation from the Support Tool. The screen shown
below will be displayed during the transfer.
Abort:
Transmit Mode
KB
PT --> Host
Host --> PT
Screen Data
System Memory
Memory Tables
Mark Data
History Data
Number of bytes transferred (in kilobytes).
Press these three System Keys simulta-
neously to stop the transfer in progress.
Shows direction
of data transfer.
Shows type of data.
4. In the event of a disconnected cable or other disruption while the trans-
fer is in progress, the PT screen will go blank and a message telling you
that transfer was not possible will be displayed at the Support Tool. If the
transfer is completed successfully, then at the end of the transfer the PT
screen will go blank and a message telling you that the transfer has
been completed will be displayed at the Support Tool.
5. To return from Transmit Mode to RUN Mode, press the Buzzer Key, Up
Key, and Down Key simultaneously.
Note After completion of the transfer, be sure to change to Maintenance Mode. If
power is turned off or the reset switch is pressed before changing to Mainte-
nance Mode, the data that is transferred will be damaged.
When using the EEPROM as a screen data memory, screens cannot be
transferred screen by screen from the Support Tool to the PT. The screen
data must be transferred in file units after initializing the memory.
3-4 Initial Settings
When power is turned on, the PT’s internal status is initialized to the following
settings.
Item Initial value
Character string memory Screen data memory content
Numeral memory Screen data memory content
Lamp/touch switch status OFF
Key Press Sound ON (When a battery is installed, the previously set
value is retained.)
Backlight Off 10 minutes (When battery is installed, the
previously set value is retained.)
Display No display or initial screen (At the Support Tool you
can set either no display or initial screen.)
Initial Settings
Section 3-4