135
Serial Communications
Section 6-1
Note
When the Serial Gateway function is used, the FQM1 receives FINS com-
mands (encapsulated W-series or SMARTSTEP commands) via the RS-422A
port from NT-series PTs or personal computers and converts them to W-
series or SMARTSTEP Servo Driver commands (removes the encapsulation)
and transfers them to the W-series or SMARTSTEP Servo Drivers.
System Setup
Note
The settings are made using CX-Programmer Ver. 5.0
@
menus.
Smart Active Parts
Communications Settings
When using NS-series Smart Active Parts for Servo Drivers with the FQM1,
set the Destination Unit No. (U) to 251 on the Smart Active Parts Communica-
tions Settings Screen. No. 251 indicates the RS-422A port for the FQM1.
FQM1
Smart Active Parts
RS-422A
NS-series PT
NT Link
Coordinator Module
Protocol
conversion
Servo parameters or
other data
W-series or
SMARTSTEP
Servo Driver
W-series or
SMARTSTEP
Servo Driver
Item
Settings
Default
Enabled
Drive Tab Page
Mode
Serial Gateway or Non-procedural
(no-protocol)
Serial Gateway
Each cycle
RS-422 Response Time-
out of Command
0.1 to 25.5 s (unit: 0.1 s)
5 s
Содержание HOME SECURITY SYSTEM - MOTION SENSOR FQM1-CM001
