Omron F3SG-PG Series, Руководство пользователя, Страница: 299 / 473

269
F3SG-SR/PG
User’s Manual
Chapter
4
M
onitor
in
g
with
SD M
a
nag
e
r
3
Setting with SD Manager 3
E
4.
Check the analysis data (10) to see if there is any unnecessary data.
It is possible to delete unnecessary data by selecting the data on the screen and pressing the [Delete]
key. The table (7) and chart (11) will be updated each time analysis data is deleted.
If you have deleted analysis data accidentally, click the [Retrieve log] button again to recall it.
5.
Select a desired standard deviation range (9) from the pull-down menu.
6.
The flowchart below shows an example to optimize setting parameters of muting input time difference
based on analysis data.
7.
Adjusting the T1 Min and T1 Max closer to the A.D. Min and Max allows the user to keep the
productivity and improve the safety.
The following operations in Step 7 are unnecessary if the T1 Min and T1 Max are fairly close to the A.D. Min and Max.
If you change T1 Min and T1 Max, make sure that these values satisfies "T1 Min < A.D. Min < A.D. Max < T1 Max".
Is j u dgment in chart (7) red?
N o
Yes
Is the range of A.D.
b et w een T1 Min and T1 Max?
N o
Optimizing m u ting setting parameters
Is j u dgment in chart (7) yello w ?
N o
Yes
Yes
J u dgment in chart (7) is green.
The m u ting is possi b le w ith c u rrent
settings and installation.
Go to Step 7 to keep the
prod u cti v ity and impro v e the safety
in the c u rrent conditions.
There is analysis data o u t of the range of A.D. Min to Max.
Take example sol u tions b elo w .
1) Delete any u nnecessary analysis data (10).
2) Select another standard de v iation range v al u e.
The range of A.D. Min to Max is o u t of the range T1 min to T1 max.
Take example sol u tions b elo w .
1) Delete any u nnecessary analysis data (10).
2) Select another standard de v iation range v al u e.
3) Change T1min and T1max on the m u ting time information setting
screen.
Analysis data is o u t of the range of T1 Min to T1 Max, res u lting in a
m u ting se qu ence error.
Take example sol u tions b elo w .
1) Delete any u nnecessary analysis data (10).
2) Change T1min/T1max v al u e in M u ting setting screen.
3) Change T1min and T1max v al u es on the m u ting time information
setting screen.
4) Change installation conditions and retrie v e logs again.