Omron EasySpeed 3G3JE, Руководство пользователя

Страница: 39 / 133

Chapter 2
2-17
Design
1. When connecting one solderless terminal to each terminal, use the following size
.
2. When connecting two solderless terminals to each terminal, use the following size.
3. When connecting one 2-wire (twin) solderless terminal to each terminal, use the following size.
● Wiring Method
Wire the control I/O terminals using the following procedure.
1. Loosen the terminal screws with a thin flat-blade screwdriver.
2. Insert the wires from underneath the terminal block.
3. Tighten the terminal screws to the torque specified in the previous table.
Note Applying a torque that is greater than the specified torque may damage the terminal block. If
the tightening torque is insufficient, however, it may cause malfunction or short circuiting.
Terminal
screw size
Tightening
torque
(N·m)
Wire Solderless terminal
size (mm
2
)
Insulating
sleeve
Recommended
solderless terminal
model
(Mfd. by Phoenix
Contact)
M3 0.5 to 0.6 Stranded
wire 0.25 to 1.5 With/without AI 0,25-6 BU
AI 0,34-8 TQ
AI 0,5-8 WH
AI 0,75-8 GY
AI 1-8 RD
AI 1,5-8 BK
Terminal
screw size
Tightening
torque
(N·m)
Wire Solderless terminal
size (mm
2
)
Insulating
sleeve
Recommended
solderless terminal
model
(Mfd. by Phoenix
Contact)
M3 0.5 to 0.6 Stranded
wire 0.25 to 0.5 Without A 0,5-6
Terminal
screw size
Tightening
torque
(N·m)
Wire Solderless terminal
size (mm
2
)
Insulating
sleeve
Recommended
solderless terminal
model
(Mfd. by Phoenix
Contact)
M3 0.5 to 0.6 Stranded
wire 0.5 to 1 With AI-TWIN 2x0,5-8 WH
AI-TWIN 2x0,75-8 GY
AI-TWIN 2x1-8 RD
Thin flat-blade screwdriver
Terminal block
Wires
Strip the end for approx.
6 mm if a solderless
terminal is not used.
Attach solderless terminal
or wire without soldering.