Omron CJ1W-SCU41, Руководство по эксплуатации

Страница: 232 / 526

213
CompoWay/F Master Protocol Appendix B
Example: The following example illustrates reading the present value from a K3N
#
-series Intelligent Signal
Processor.
Sequence No. 600 (Send with ASCII Conversion, with Response) is used. The specified data beginning with
the command code is converted ASCII and sent to the Intelligent Signal Processor with the specified node
number. The response is converted to hexadecimal and stored starting at the specified word.
The command frame for reading the present value for a K3N
#
-
####
-FLK1/2/3/4/5/6 Intelligent Signal Pro-
cessor (command code 01 01) is shown below. The following data is specified in the operands for PMCR(260).
• Rightmost byte of S+1: Node number (2 digits BCD)
• S+2: Command code: MRC + SRC = “0101”
• S+4 on: Send data = Variable type + first read a 00 + number of elements.
Data in shaded portions is specified in the PMCR(260) instruction.
Note A first read address of 0000 specifies the present value. An address of 0001 specifies the maximum
value; 0002, the minimum value; and 0003, the status.
The response frame is shown below. The response code and receive data are stored according to the oper-
ands for PMCR(260) as follows:
• D+1: Response code
‡
D+2 and on: Receive data
Data in shaded portions is stored at the location specified by the operand in the PMCR(260) instruction.
Note 1. Response Codes
STX Node No. Subad-
dress
SID Command code Send data ETX BCC
MRC SRC Variable
type
First read
address
(Note)
Always
00
No. of ele-
ments
(02Hex)
(
×
10
1
) (
×
10
1
)
00 0 01 01 C0 0000 00 0001 (03Hex)
STX Node No. Subad-
dress
End
code
Command code Response code Receive
data
ETX BCC
MRC SRC Note 1 Read data
(Note 2)
(02
Hex)
(
×
10
1
) (
×
10
1
)
01 01 00 00 0000 (03
Hex)
CS/CJ-series PC
CompoWay/F response
Read data = present value
CompoWay/F command
VARIABLE AREA READ
Command code: 01 01
First read address
Intelligent Signal Processor
K3N
#
-
####
-FLK1/2/3/4/5/6
Response code Meaning
“0000” Normal end
“1001” Command too long
“1002” Command too short
“1100” Parameter error
“1101” Area type error
“1103” First address range error
“2203” Operating error