Omron 3G3MV-P10CDT-E, Руководство пользователя

Страница: 29 / 110

Introduction
SECTION 1
1-5 Preparation for Operation
Follow the steps listed below when setting up a 3G3MV-P10CDT system.
1, 2, 3... 1. System Design
•
Select a 3G3MV-P10CDT Unit with the specifications required in the
controlled system.
•
Design external fail-safe circuits such as interlock circuits and limit cir-
cuits.
2. Installation
•
Install the Unit on the Inverter
3. Wiring
•
Wire the Inverter and I/O devices.
•
Connect communications devices if necessary.
•
Connect the Programming Console.
4. Initial Settings
•
Set the Communications Switches on the front of the CPU Unit, if nec-
essary. (The switches must be set when a device other than the Pro-
gramming Console is connected or the standard communications set-
tings are not used.)
•
Connect the Programming Console, set the mode switch to PROGRAM
mode, and turn ON the Inverter.
•
Check the Unit’s LED indicators and the Programming Console’s dis-
play.
•
Clear the PLC’s memory. (All Clear)
•
Make PLC Setup settings.
5. Create Ladder Program
•
Create a ladder program to control the system.
6. Write Ladder Program in PLC
•
Write the ladder program in the PLC with the Programming Console or
transfer the program to the PLC from the Support Software.
7. Test Run
•
Check I/O wiring in PROGRAM mode.
•
Check and debug program execution in MONITOR mode.
16