6. Install the filter assembly onto the mounting screws installed in
step 2 and tighten the mounting screws. See Figure 8.
Finish Connecting the Tubing; See Figure 9.
1. Connect one piece of the poly tubing from the “IN” port of the
filter housing to the saddle valve inlet port. To connect the tubing:
a. Slide the brass compression nut over the end of the poly
tubing.
b. Slide the white plastic compression sleeve over the poly tub-
ing and into the compression nut.
c. Slide the brass insert into the poly tubing.
d. Screw the tubing assembly onto each of the ports as illustrat-
ed in Figure 9.
2. Connect the other piece of poly tubing from the faucet stem to
the “OUT” port of the filter housing.
Turn on the Water
1. Open the filter faucet and then slowly open the cold water shut
off valve.
2. To remove the air from the filter run the water for 30 minutes,
until the water runs clear.
NOTE:
Some trapped air may exist for the first few days of
operation.
3. Check for leaks at all the fittings.
For further operating, installation, or
maintenance assistance:
Call Omnifilter Customer Service
at 800-937-6664
3
Mounting
Screws
1/4"
Figure 8
9 0600 CBF1
Brass Compression
Nut
White Compression
Sleeve over the
Plastic
Brass Insert
Poly Tubing
Tubing and Fitting
Assembly (Parts
listed above)
In
Port
Out
Port
Faucet
Stem
Tubing and Fitting Assembly:
Saddle
Valve
Inlet
Port
Figure 9
System tested and certified by NSF
International against ANSI/NSF
Standard 42 for the reduction of
chlorine taste and odor and nominal
particulate reduction Class
I
and
against ANSI/NSF Standard 53 for
the reduction of Cysts.
