If there is a protected entry still open or the impact sensor still in a violated state at the end of 30 seconds,
the system will reactivate for two more 30 second cycles. In this case the system will stop after a total
of 3 cycles and rearm automatically, and then ignore only the open entry or violated sensor. When the
entry is closed or the sensor is reset, protection will begin instantly for the formerly affected circuit.
Anytime the security system triggers, the Status Light will indicate which protected zone triggered
the system by flashing two, three or four times between pauses. This “Zone Violation” code will
continue to flash, even after disarming. The system can hold two different violation codes in it's
memory, which is cleared by turning the ignition switch "on".
Once the K-9 has been activated and reset, the disarming confirmation changes to make the user
aware that it has done so. This is explained in the next section.
Page - 9
There are two methods of disarming the K-9:
Disarming the System
Disarming the System Using the Transmitter
2-
The second method is an “
Emergency Override
” alternative, should the transmitter become lost
or inoperable. This method uses the Valet Switch, but the vehicle’s ignition key is also required.
1-
The primary method is to use the
transmitter
, by pressing and releasing its “disarm/unlock”
button. This is the normal “daily use” method.
Press and release the transmitter’s “disarm/unlock” button once to instantly disarm the
system, disengaging the starter interrupt and unlock the doors. If you have the optional unlock driver's
door feature, then upon disarming only the driver's door will unlock, and if the transmitter’s “disarm/
unlock” button is pressed again at anytime thereafter, all of the doors will unlock.
Step 1 -
Turn the ignition "off", and press the Valet Switch 5
times.
(the system will respond by briefly sounding the siren)
Step 2 -
Press the Valet Switch the same number of times as
the feature number.
(the system will acknowledge the Valet Switch entry by
repeating the same number of chirps)
Step 3 -
Press the transmitter's “
arm/lock
” button to turn the
feature
"on", or press the “
disarm/unlock
” button to turn
the feature "off". (turning the feature "on" is indicated by
one siren chirp; turning the feature "off" is indicated by two
siren chirps)
Repeat - Steps 2 and 3 for each feature to be changed
This checklist helps when programming features. Before
attempting feature programming, please first carefully read
pages 23-24 to become familiar with the programming proce-
dure, and features’ descriptions which start on page 25. Mark
each applicable box with "\" next to the feature to be changed
before entering Features Programming Mode. As each feature
is programmed, change its mark to "X".
Features Programming Checklist
#
F
EATURE
DEFAULT
Page - 32
