The
2nd channel output
, which is operated by pressing and holding the transmitter’s “
II
” button
for 1 second, is designed specifically to operate your vehicle’s electric power trunk release. Your
vehicle will respond by releasing the trunk lid or rear hatch, chirping the siren twice, turning on your
parking and interior lights for 30 seconds, unlocking the doors, and disarming the system if it was
armed. The 2nd channel output will not operate when the ignition switch is "on" unless the vehicle's
door is open. If desired, the security system can be programmed to remain armed when this feature is
used, and connection of the 2nd channel may require extra parts or installation.
Your K-9 vehicle security system is designed to easily add an optional auxiliary impact sensor
which will greatly increase the effectiveness of your system. A light shock or impact to the vehicle will
initiate Prewarning, while a heavier shock or impact will fully activate the security system. Several
types of sensors are available, including a radar-technology sensor that can detect moving objects inside
and outside the vehicle.
The optional sensor may be temporarily bypassed using the transmitter- within 3 seconds after
arming the system, by pressing the “
II
” button. The system will respond with one chirp, confirming
that the sensor is bypassed. If the system is triggered by the shock sensor, the Zone Violation feature
will flash the Status Light four times between pauses.
When the optional sensor is triggered by a light impact or shock to the vehicle, the security system
will respond by chirping the siren 3 times and locking the doors. After this Prewarning circuit has been
triggered five times it will automatically shutdown until the alarm system is disarmed, then armed. This
will prevent the security system from being a nuisance to the general public, and in some cases allowing
compliance with local noise ordinances.
Optional Auxiliary Shock Sensor with Prewarning
Page - 18
2nd Channel and 3rd Channel Outputs
Page - 23
How to Program Features
The K-9 has 25 programmable features, most of which allow the user to customize the system’s
operation (several programmable features are installation-related). “Features Programming Mode” is
the process for changing these features. The vehicle ignition key and the Valet Switch are used to enter
the Programming Mode, then the transmitter is used to change features. Once the system is in
Programming Mode, a 10 second period without programming activity will cause the system to
automatically exit Programming Mode. Features can be selected in any order as desired.
To Enter Programing Mode and Change Features:
Step 4
Within 10 seconds, press and release the Valet Switch the same number of times as the
desired feature’s number.
• The siren will chirp and the Status Light will flash the same number times as the Valet
Switch was pressed to indicate the feature number which may now be programmed..
To Access a Feature:
Step 3
Within 5 seconds, press and release the Valet Switch 5 times.
• The siren will chirp then sound briefly and the Status Light will flash to confirm that the
system is entering Programing Mode.
• Once in Programming Mode, if 10 seconds of no programming activity occurs, the system
will exit Programming Mode. Programming activity is the pressing of the Valet Switch to
select a feature or pressing a transmitter button once a feature is selected.
Step 2
Turn the ignition off.
Step 1
Turn the vehicles’s ignition on.
