![background image](http://html2.mh-extra.com/html/omega/compact-cal-ca100/compact-cal-ca100_owners-manual_5154776049.webp)
48
CW
Writes the calibration data.
Syntax for setting
CW <terminator>
Description
• The result of calculation is
written to the EEPROM after
completing calibration.
• If the calibration point is not set,
error 16 occurs indicating a
calibration error.
ESC S
Outputs a status byte.
Syntax for setting
ESC S <terminator>
Description
• This outputs the status byte (n=0
to 127, n represents the decimal
number converted from the
binaries of bits 0 to 7) generated
by the instrument. For details on
the status byte, see page App-5.
H
Enables/Disables the header addition to the output data/
queries the current setting.
Syntax for setting
Hm <terminator>
m=0: Disabled
1: Enabled
Syntax for query
H? <terminator>
Example of response
H1
Description
For details on the header, see the
output format of measured values
on page App-5.
KT
Selects the key type used and queries the current setting.
Syntax for setting
KTm <terminator>
m=0: Up/Down key
1: Numeric keypad
Syntax of query
KT? <terminator>
Example of response
KT0
MO
Starts/stops measurement/queries the current setting.
Syntax for setting
MOm <terminator>
m=0: Stop measurement
1: Start measurement
Syntax of query
MO? <terminator>
Example of response
MO1
MR
Specifies the calibration range for measurement/queries
the current setting.
Syntax for setting
MR m <terminator>
DCV
DCA
Resistance
m=0: 500 mV 20 mA 500
Ω
1:5 V
100 mA 5 k
Ω
2:35 V
-
50 k
Ω
Syntax of query
MR? <terminator>
Example of response
MR0
OD
Outputs measured data.
Syntax for query
OD <terminator>
Description
For the output format of the
measured data, see page App-5.
OE
Outputs error information.
Syntax for query
OE <terminator>
Example of response
ERR11
Description
• Outputs a recently occurred
error.
• For the meanings of error
numbers, see the troubleshooting
section (page 40).
SO
Starts or ends generation/queries the current setting.
Syntax for setting
SOm <terminator>
m=0: Stop generation
1: Start generation
Syntax of query
SO? <terminator>
Example of response
SO1
SR
Specifies the calibration range for generation/queries the
current setting.
Syntax for setting
SRm <terminator>
DCV
DCA
Resistance
m= 0: 100 mV 20 mA
500
Ω
(1 mA)
1: 1 V
-
5 k
Ω
(1 mA)
2: 10 V
SINK
50 k
Ω
3: -
-
500
Ω
(5 mA)
4: -
-
5 k
Ω
(5 mA)
Syntax of query
SR? <terminator>
Example of response
SR0
Description
• If the range is changed during
generation, the generation is
turned off. To turn on the
generation, issue an SO
command again.
Free Datasheet http://www.datasheet-pdf.com/