Omega CN76000, Руководство пользователя

Страница: 6 / 54

4
3. To remove the logic jumper strip, carefully insert a small flat blade screwdri ver between the retaining
clip and the jumper at one end of the jumper strip. Apply slight pressure to move the clip aw ay from
the jumper end until it is released, then lift it up and out of the clip.
4. To re-install the jumper strip, hold it with the spring contacts in the desired position. Face springs up up
up up
up
for S S R S S R S S R S S R S S R or MECHANICAL RELA MECHANICAL RELA MECHANICAL RELA MECHANICAL RELA MECHANICAL RELAY Y Y Y Y outputs, or face springs do do do do dow n w n w n w n w n for 5 5 5 5 5 Vdc Vdc Vdc Vdc Vdc outputs. Insert one end
of the jumper strip under the retaining clip and press the other end down until the remaining clip
engages the jumper.
5. To avoid any damage, recheck the jumper installation and the housing rear terminal panel output
wiring.
6. Replace the instrument into its housing.
INPUT INPUT
INPUT INPUT INPUT WIRING
WIRING
WIRING WIRING WIRING
Do not run thermocouple or other input wiring in the same conduit as pow er leads. Use only the type
of thermocouple or RTD probe for which the control has been programmed. See the "Secure Menu"
for input selection.
For thermocouple input always use extension leads of the same type designated for your thermo-
couple.