Omega CN76000, Руководство пользователя

Страница: 4 / 54

2
U N P U N P U N P U N P U N PA A A A A CKING CKING CKING CKING CKING
Remove the packing list and verify that all equipment has been received. If there are any
questions about the shipment, please call OMEGA Customer Service Department at 1-800-622-
2378 or (203) 359-1660.
Upon receipt of the shipment, inspect the container and equipment for any signs of damage. Take
particular note of any evidence of rough handling in transit. Immediately report any damage to
the shipping agent.
N O T E N O T E
N O T E N O T E N O T E
The carrier will not honor any claims unless all shipping material is saved for their examination.
After examining and removing contents, save packing material and carton in the event reshipment
is necessary.
INST INST
INST INST INSTA L L A
A L L A
A L L A A L L A A L L ATION
TION
TION TION TION
Mount the instrument in a location that will not be subject to excessive temperature, shock ,
or vibration. All models are designed for mounting in an enclosed panel.
Select the position desired for the instrument on the panel.
If more than one instrument is required, only two units can
be mounted closely together, either one above the other
or side by side. When mounted together, the mounting
collar will require modification by removing the inside tab
from each collar.
Prepare the panel by cutting and deburring the required opening.
From the front of the panel, slide the hous-
ing through the cut out.
The housing gasket
should be against the housing flange be-
fore installing.
From the rear of the panel slide the mount-
ing collar over the housing. Hold the hous-
ing with one hand and using the other hand,
push the collar evenly against the panel until the spring loops are slightly compressed.
The
ratchets will hold the mounting collar and housing in place.
DIMENSIONS DIMENSIONS
DIMENSIONS DIMENSIONS
DIMENSIONS
REMOVE
45mm
(1.77")
45mm
(1.77")
93.2mm
(3.670") 19mm
(0.75")
ALL TOLERANCES ARE
-0.00 +0.25mm (-0.000 +0.010)
PANEL CUTOUT
FOR SINGLE
INSTRUMENT
PANEL CUTOUT
FOR 2
INSTRUMENTS
MOUNTED TOP
AND BOTTOM
OR SIDE BY
SIDE