Section 3
– Installation
Page 22
09/11/2008 REV 0.99
3.6
USB Connection
There are two USB (Universal Serial Bus) Connectors on the rear panel.
One is a Type A Master connector; the other is a Type B Slave
connector. Only one can be active at any time
– the active connector is
selected by a
slide switch
on the under side of the recorder close to the
back panel. The switch is set below the surface. Slide the switch toward
the connector you want active
– A or B BEFORE powering up the unit.
Use standard shielded USB connector cables to connect to your USB
device (Host PC to USB B
– Slave Device to USB A Host port).
Note: Maximum cable length should not exceed 5m (15 feet).
3.7
Audio Connection
The audio output connector is a 6 pin mini din socket that permits connection to the
recorders audio lines. Connections are as follows:
Pin
Direction
Description
1
Out
Audio Common
2
In
Microphone Input
3
Out
Line Output
– Left
5
Out
Line Output
– Right
4
In
Line Input - Left
6
In
Line Input - Right
An adapter is available that converts the Mini Din to 3 Standard Phone Jacks for
Microphone In, Line In and Line Out.
3.8
Mouse and Keyboard Connection
The keyboard / mouse connector is a 6 pin mini din socket that permits connection to an
external mouse and/or keypad. A standard PS2 mouse will plug directly into this socket, a
PS2 keyboard needs an adapter. Connections are as follows:
Pin
Direction
Description
4
Out
+V for Keyboard/Mouse
3
Out
Supply Common for Keyboard/Mouse
1
In/Out
Mouse Data Line
5
In
Mouse Clock Line
2
In/Out
Keyboard Data Line
6
In
Keyboard Clock Line
An adapter is available that converts the single Mini Din Socket to two separate sockets, one for the mouse and
one for the keyboard.
Figure 3-13
Figure 3-14
Figure 3-15
