OMEGA AIR A-DRY Series, Инструкция по установке и эксплуатации

Страница: 61 / 65

61
14.5.4 Tower fails to depressurise
Description:
During normal operation there is a 4 min interval of purge air release when the tower
depressurizes in every-half cycle. During a half-cycle there is no regeneration/purge flow
interval on one or both towers.
Possible causes, inspection and fixing procedure:
1. No power supply, controller is OFF : Connect the power supply.
2. Dryer is in a STAND-BY MODE : Inspect the source of the STAND-BY signal.
3. Faulty control purge release valve : Inspect the control valve coils. If one or more the
coils keeps warming up considerably compared to other coils then the coil is
malfunctioning and could be causing the failure to open the purge release valve
during the regeneration/purge interval. Order the control valves service kit. For more
information see
14.2 Control Valves .
4. Clogged nozzle: Inspect the nozzle. If it is clogged, clean it! For more information see
13.5 Replacement of the nozzles.
5. Malfunctioning manometer: In this case the dryer is operating correctly but a faulty
manometer indicates that the tower has not depressurized. If the manometer is
faulty it will show that the tower is pressurized even when the dryer is offline and
unpressurised. Contact your supplier and replace the manometer.
Manometer indication on unpressurised dryer
tower