Attaching the Diamond Conductive Tape for Electric Guitars
In this step you attach the snap-connector of the flexible Diamond Conductive Tape to the Add-
On Device, lay it on the body of your guitar in a pleasing shape, bring it up the neck of the
guitar to just below the thirteenth fret, trim it to size, and then solder it to the Flat Conductive
Tape.
Before continuing, make sure that the area of the snap is still clean.
OMB
1
2 3
4
"
5
6
8
7
OMB
9
1
Lift the snap connector of the Base slightly, remove the adhesive backing, and press it to the
body of the guitar.
2
Take the diamond conductive tape and press its snap connector on the base until you hear it
snap.
3
Remove a portion of the adhesive strip from the diamond conductive tape and attach the first
few segments to the body of the guitar.
4
Plan out a design that matches the lines of your guitar—or go crazy and form any shape that
suits your mood—keeping the following in mind:
• The end of the Diamond Conductive Tape, after trimming, must be soldered on the
copper point at the end of the flat conductive tape.
• Avoid creating sharp corners in order to prevent damage to the Diamond Conductive
Tape
5
Once you have an idea for your design, take a look at the diamond conductive tape and
notice the conductive copper that is visible in the last nine segments.
Attaching the Diamond Conductive Tape for Electric Guitars
25
OMB User Guide - Version 0.I
