Attaching the Add-On Device to String-Through Body Electric Guitars
In this step you will attach the Add-On Device to your guitar, which includes the means to
prevent your strings from touching any metal part of your guitar. If you have a hard-tail bridge
electric guitar go to
Attaching the Add-On Device to Hard-Tail Bridge Electric Guitars
(page 18).
If you have a Tune-o-matic bridge electric guitar go to
Attaching the Add-On Device to Tune-o-
matic Bridge Electric Guitars
(page 20).
3
4
1
2
1
With a pair of scissors, cut the flex connector on the third perforation after the large set of
holes. Discard the excess where your community collects recyclable electronics.
2
Take a clipper and cut the bracing member off of the String-through spacer block, and then
discard it.
3
Now trim the end of each of the exposed tubes so that theyhave a sharp narrow point. This
point eases the passage through the guitar string holes in the next step.
4
Continue with the rest of the exposed tubes.
Attaching the Add-On Device to String-Through Body Electric Guitars
14
OMB User Guide - Version 0.I
