PV8355F4E007 13
3.3.Device connection
Wire as shown in the figure below.
Name
Connection
1
Lamp cable
Co
nnects the “LAMP” connector of the lamp housing and the “LAMP2” connector
of the controller supply unit
2
IO cable
Connects the “IO” connector of the main set and the “IO” connector of the
controller supply unit
3
USB cables (2)
Connects the “USB1” and “USB2” connectors of the main set and any USB
terminals of a personal computer (Cables and ports are not distinguished.)
4
Power cord
Connects the power plug to a power supply of 100 to 240 V; connect this to a
three-hole wall outlet with a grounding point when using a power cord. Our
intended electrical safety performance cannot be secured when the wall outlet is
not grounded.
5
Protection key
Any USB port on the computer
The power cord may melt and short-circuit if it makes contact with
the lamp housing. Keep the power cord sufficiently away from the
lamp housing during installation.
Be sure to use the attached cable. Use of something other than the
attached cable may cause a failure such as noise occurrence or
malfunction due to external noises. The attached cable cannot be
used for other equipment.
For cable setting, keep cables away from something sharp.
Be careful not to apply excessive force, as cables are susceptible to
bending and torsion.
Confirm that all power switches are set to OFF and that the power
cord has been removed from the wall outlet.
3. USB cable
3. USB cable
1. Lamp cable
2. IO cable
4. Power cord
USB1
USB2
IO
LAMP
LAMP
IO
5. Protection key
