– 7 –
3.1 Orient the arm to the direction to be used
3.2 Attaching the drape
1
This instrument is designed to allow a wide range of
arm positions by enabling “Installation of base on the
right of operator (a)” and “Installation of base on the
left of operator (b)”. Perform the following operation
according to the desired positioning of the arm.
The following steps describe how to change the “Installation of base on the right of operator” to “Installation of
base on the left of operator”. If you need the opposite work, reverse the left and right in the following steps.
2
Press the scope switch C on the microscope
section and rotate the microscope section
around rotation axis A shown in (a) by 180
toward the front (in the direction of arrow 1) to
the positioning shown in (b). Then rotate the
microscope section around rotation axis B in
the direction of arrow 2 to change the arm
positioning as shown in (c).
1
To facilitate attaching of the drape, press the scope switch
C on the microscope section and extend the arm as shown
in Figure.
2
Take out the drape from the package.
3
Open the drape in the direction of the arrow.
4
Check for adhesion of foreign matter to drape, wetting due to water, etc. If there is an abnormity, replace with
new drape.
3 Operation
(a)
(b)
Operator
Base
Base
Rotation
axis A
Arrow 1
Microscope
section
Scope
switch C
(a)
(b)
(c)
Rotation
axis B
Arrow 2
Arm
Microscope section
Scope switch C
Package
Drape
Arrow
