Olympus OEP-5, Инструкция по эксплуатации, Страница: 67 / 88

S
yst
e
m
S
e
tu
p
5
5.13 Setup of the “COLOR ADJUST” Menu
67
Setting “CYN-RED,” “MAG-GRN,” “YEL-BLU”
This item is used to adjust the color tone in 15 steps in
the printed picture and the image on the monitor.
The color tone in the printed picture and the image on
the monitor is changed as Table 5.5 by changing the
setting value.
1
Press “
v
” or “
V
” to select from “CYN-RED,”
“MAG-GRN” or “YEL-BLU,” and press the
“ENTER” button.
2
Press “
v
” or “
V
” to select between “-7” and “7,”
and press the “ENTER” button.
Setting “DARK”
This item is used to adjust the dark area in the printed
picture in 15 steps.
1
Press “
v
” or “
V
” to select “DARK,” and press the
“ENTER” button.
2
Press “
v
” or “
V
” to select between “-7” and “7,”
and press the “ENTER” button.
Setting “LIGHT”
This item is used to adjust the bright area in the printed
picture in 15 steps.
1
Press “
v
” or “
V
” to select “LIGHT,” and press the
“ENTER” button.
2
Press “
v
” or “
V
” to select between “-7” and “7,”
and press the “ENTER” button.
Setting “SD SHARPNESS”
This item is used to set the level of the edge
enhancement in the printed picture when an SDTV
signal is input to this instrument. Increasing this value
increases the enhancement level.
If the enhancement level is too high, the printed picture
may look rough. If it is too low, the printed picture may
look blurred.
This setup is valid only for the printed picture and is not
applied to the signal output to the monitor.
1
Press “
v
” or “
V
” to select “SD SHARPNESS,” and
press the “ENTER” button.
2
Press “
v
” or “
V
” to select between “1” and “15,”
and press the “ENTER” button.
Setting “HD SHARPNESS”
Refer to the “Setting “HD SHARPNESS”” on page 63.
Setting “SAVE COLOR”
This item is used to save the setups made in “COLOR
ADJUST” menu. When the setup of any item is changed
in the “COLOR ADJUST” menu, the “TEMP” indicator
is displayed on the menu screen, indicating that at least
one setup has been changed from the current value. If
this instrument is turned OFF while the “TEMP”
indicator is displayed, the changed setups will not be
saved. To save the changed setups, save them in the
following steps.
1
Press “
v
” or “
V
” to select “SAVE COLOR,” and
press the “ENTER” button.
2
Press “
v
” or “
V
” to select from among “1,” “2” and
“3,” and press the “ENTER” button.
3
Press the “ENTER” button to save the setups.
Confirm that the “TEMP” indicator disappears.
Table 5.5
Setting Item
Setting Value
decrease increase
CYN-RED Enhanced cyan Enhanced red
MAG-GRN Enhanced magenta Enhanced green
YEL-BLU Enhanced yellow Enhanced blue