Laser intensity change
/
The way of changing the emission area (ROI / REX) and intensity of Laser with LD Interface configuration
(FV1000 system)
IV.
OPERATION INSTRUCTIONS
IV.
3 - 3
Page
3-3 The way of changing the emission area(ROI / REX) and intensity of
Laser with LD Interface (FV10-LDIF) configuration (FV1000 system)
When FV1000 is used and FV10-LDIF, laser intensity and laser emission area (ROI /
REX) can be changed. For further details, see instruction manual for FV1000. Laser
intensity can be changed from 1% to 100% if the maximum value is set to 100%.
1.
Connect FV10-LDIF with FV5-LDPSU(Type2).
2.
Set ROI / REX from FV10-ASW / FV10-SW software.
3.
After ROI / REX setting, start scanning so that laser emission area can be changed.
Intensity can also be changed with scale setting of [Laser] group box (when
you use FV10-ASW) or [Laser Intensity] group box (when you use FV10-
SW). In case that FV10-LDIF is used, the laser intensity can be changed
from 1% to 100% if the maximum value is set to 100%.
Do not change back panel switch settings done at our setup time on
FV5-LDPSU.
For further details, see [Back panel switch settings].
When you use this system as standalone, refer to Chapter 2 [Laser
emission].
TIP
NOTE
TIP
Содержание FV5-LD405
