Olympus FV5-LD405, Руководство пользователя

Страница: 88 / 92

Warning to back panel switch settings
/ Dip Switch Settings
VI. BACK PANEL SWITCH SETTINGS
VI.
1 - 2
Page
z DIP switch
5
should be set to
OFF
position in case that electric shutter
is controlled in remote mode with FV300 or FV500. In addition, laser does not
emit if the shutter switch were turned to CLOSE. When you wish to control
the electric shutter in remote mode, turn the shutter switch to OPEN all the
time. When you use this system without connecting with FV300 or FV500,
set this switch to
ON
position. OPEN/CLOSE operation of shutter switch
makes electric shutter open or close.
In case that this system is connected with FV300 or FV500, set
DIP switch 5 to OFF position for sure. If you use this system with
DIP switch set to ON position, it is very dangerous as control
from FV300 / FV500 software is not possible.
In case that this system is connected with FV1000, set DIP switch 5
to ON position for sure. If you use this system with DIP switch set
to OFF position, it is very dangerous as control from FV10-
ASW /FV10-SW software is not possible.
z
DIP switch
6
should be set to
OFF
position in case that FV5-LCU of FV300
or FV500 is not connected with FV5-LDPSU with use of BNC cable.
When connecting, set it to
ON
position. If it were set to ON position,
REX function of FV5-LCU can be used. Regarding REX function, refer to
IV section 3-2. For further details, see manual of FV300 or FV500.
Default settings of all DIP switches are set to OFF when our system
is shipped. However, in case that you use FV300, FV500 or FV1000,
our service personnel would make the DIP switch settings properly.
In case that this system is connected with FV1000, set DIP switch 6
to OFF position for sure. If you use this system with DIP switch set
to ON position, it is very dangerous as control from FV10-ASW / FV10-
SW software is not possible.
TIP