Troubleshooting
10
Ap
pen
d
ix
181
Halation produces unnatural colors in the picture.
This may be caused by
excessively bright
ultraviolet light on the
subject, such as sunlight
shining through the
leaves of trees, window
frames in bright light at
night, reflection of metal
in direct sunlight, etc.
Use an Olympus UV filter. As this may upset
the overall color balance, it should only be
used in the conditions described on the left.
If the discoloration persists, touch up the
picture using a graphics application. For
details, refer to the manual for the graphics
application you are using.
–
Pictures you have taken do not appear on the monitor.
The power is off.
Set the mode dial to
q
, then turn the power
switch to ON.
P. 13
The camera is in the
shooting mode.
Press the
QUICK VIEW
button or set the
mode dial to
q
.
P. 13,
16
There are no pictures on
the card.
[NO PICTURE] is displayed on the monitor.
Record pictures.
–
There is a problem with
the card.
See “Error codes”.
P. 174
The camera is
connected to a TV.
The monitor does not function when the AV
cable is connected to the camera.
P. 112
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Display pictures with
9
and press the
0
button to cancel protection.
P. 115
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
Set the video output signal according to the
region where used.
P. 113
The TV video signal
setting is incorrect.
Set the TV to the video input mode.
P. 112
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Select [
s
] in [MODE MENU] and adjust the
brightness.
P. 130
The monitor is exposed
to direct sunlight.
Block the sunlight with your hand or use the
viewfinder.
–
Possible cause
Corrective action
Ref.
page
