46
Fig. 52
Fig. 53
3. Engage the objective on the back side in the light path.
Adjust focusing, read the scale indication of the fine adjustment knob
and obtain the difference from the value read in step 2 above.
4. The objective to use the washer is determined by the rotation direction of
the fine adjustment dial
2
. (Fig. 51)
· Direction of the arrow:
Objective on the front side.
· Opposite direction to the arrow: Objective on the back side.
5. Remove the objective
3
, fit the washer
5
with the required thickness on
the screw
4
, and then attach the objective again.
6. Switch the objective and confirm that confocality is implemented.
# The confocality adjustment may sometimes be unable to implement
perfect confocality.
Centering the Objective (Fig. 52)
}The centering mechanism is provided only for the objective on the front
side.
1. Adjust focusing using the objective on the front side, then move the
target region in the specimen on the center of the field.
2. Switch the objective to that on the front side.
3. Insert the centering knobs into the threaded holes
6
and turn them to
move the target in the objective on the center.
}After completing centering, store the centering knobs in the accommo-
dation position on the front side of the microscope (page 5) so as not to
lose them.
3
Attaching the Filter Turret
(Fig. 53)
}When a bridge stage or a stage with similar design is used, the filter slider
1
can be attached so that it faces toward the front of the microscope.
1. Drop in the filter frame reinforcing ring
2
into the filter holder on the
microscope frame.
2. Loosen the 2 filter turret clamping screws
3
using the provided Allen
wrench.
3. Fit the filter turret on the filter holder and tighten the clamping screws
3
lightly to a degree at which the filter turret will not rotate.
4. For the insertion of the polarizer and filters, see page 15.
3
4
5
6
1
2
3
