Olympic Medical AUTO-LENGTH 20, Инструкция по эксплуатации

Страница: 27 / 41

Page 3-7
OLYMPIC AUTO-LENGTH
™
Service
Adjusting the Optical Encoder
To adjust the optical encoder:
1. Turn the adjusting screw counterclockwise until the sensor can
be moved just to the right of the centerline of the wheel ( Fig. 3 I ).
Optical
Encoder
Wheel
Turn Screw
To Adjust
Loosen
To Adjust
Fig. 3 I
2. Initiate a measuring cycle.
3. If the cycle does not complete three readings and return to
home without showing "ERROR" on the display, turn the adjust-
ing screw 1/8 turn clockwise and try again (
Fig. 3
I
).
4. Repeat the 1/8 turn at a time until cycle completes without
showing "ERROR."
5. Tighten the sensor board fasteners, then perform the test cycle
again. Repeat until the cycle completes with tightened sensor
screws.
NOTE: It should not be necessary to turn screw more than
two full turns.