Olympia 160 V HF UF, Инструкция по эксплуатации

Страница: 50 / 92

After installing the device and setting the relevant parameter, please conduct the trial
running as follows:
-
Switch on power. Press “regeneration” and go in the Backwash status; slowly
open the inlet valve to 1/4 position (Avoiding to open the valve too quickly to damage
the device and make the resin run off); at this moment, you can hear the sound of air-
out from the drain pipeline. After all air is out of pipeline, then open inlet valve
completely and conducting 2~3 minutes backwash, cleaning the foreign materials in
the resin tank until the outlet water is clean.
-
Press “regeneration”, turning the status from Backwash to Brine& Slow Rinse;
under this status, the brine will be absorbed from the brine tank into the resin and the
resin is regenerated. After absorbing, the brine valve will close. The system will still
conduct about 15 minutes to slow rinse, wiping off the residual brine. The whole
process will take between 15 and 50 minutes to finish.
-
Press “regeneration” and turn into Brine Refill status; the brine tank will be
refilled with water to dissolve the salt. When the level controller reaches the required
height, the refilling will be stopped. The new saturated brine will be used for next
regeneration.
-
Press “regeneration”, and turn into Fast Rinse status, starting to fast rinse.
During this cycle the salt residues are removed in the resin tank for supplying fresh
water after completion of this cycle. Alongside the resin is compacted to improve its
effectiveness.
-
When the sample outlet water is qualified, press “regeneration” and finish the
fast rinse. Then the device turns into service status and start running.
9. USAGE ILLUSTRATION
50 OLYMPIA PLUS-CEASA