Olympia 160 V HF UF, Инструкция по эксплуатации

Страница: 45 / 92

You press and hold keys "validation" and "regeneration" for 5 seconds in state service and the system is placed in the language selection menu.
Screen process (User mode)
After connecting the unit to the mains, the following screen (indicating the model of the valve) is shown for 6 seconds and then will be placed in
USER mode.
L1
*******************************
F105
*******************************
Sequence of screens in SERVICE:
∩
12:30:25
∩
12:30:25
∩
12:30:25
Water System Water System Water System
Service Service Service
Water Water Water
Remaining: X.XXm ³ Cu.F.R.: X.XXm ³ /h
Regen.
Time:
2:00
State 1 State 2 State 3
Programming process of the valve. USER mode
Values Programming steps Screen
LR1
When (∩) indicator in the upper left, press and
Set Parameters
maintain (▼ ▲) for 5 seconds, until it disappears (∩)
1. Press key "validation" and enter the menu "Set Parameters"
> Set Time of Day
LR1 indicates the screen as follows. The parameter "set time of day" is
Set Regen. Time
It automatically selected.
Set Water Hardness
Watch 2. Then press “validation” and the display shows the
LR2 screen; the value of hours "12" will blink, and by (▼ ▲)
LR2
the value of the current time in that time will be adjusted.
3. Then be pressed again "validation", and the value min
Set Time of Day
"30" blinks, and by (▼ ▲) a minute value is set.
12:30
4. Finally, press "validation" and hear a "beep" that
confirms memorization of change
1. Press and enter the menu “set parameters”, as shown in
screen.
2. Press (
▼
) and select the “set. Regen. time” parameter; LR3
Then click “validation” and see the LR3 screen.
Regeneration
The hour value “02" blinks and by (▼▲) will adjust the
Set Regen. Time
time Value of hours. 02:00
3. Then again press “validation” and the value minutes
"00" blinks and by (▼▲) a minute value is set.
4. Finally, press “validation” and hear a “beep” that
Confirms memorization of change.
OLYMPIA PLUS-CEASA 45