14.
For each
Solid Wall Panel
, carefully lay panel
face down. Position and attach a
Bottom Wall
Plate
to bottom of wall studs of each wall panel with
3 - 2 1/2” Screws
. Position so plates are flush with
framing.
Parts
Solid Wall Panels
(45 1/2” x 75”)
x 7
Bottom Wall Plates
(1 1/2” x 2 1/2” x 45 1/2”)
x 7
Hardware
S1
- 2 1/2” Screws
x 21 total
Important:
Pilot hole ALL 2x3 Wall
Studs with 1/8” drill bit prior
to screwing. This will make it
much easier to attach
together.
Pilot Hole
first.
Bottom Wall Plate
Side of Shed
15.
Starting at Rear Corner, position a Solid Wall Panel
on top of plywood floor. The Wall Panel bottom framing
will sit flush with plywood. Wall siding will overhang the
floor. The Rear Wall panels will sit flush at the end of the
plywood floor with the side wall panels sandwiched
between them
Note:
Siding will overhang the floor by approximately 1/2”.
1st Rear
Wall Panel
Front of Shed
1st Rear Wall Panel
side of shed
2x3 wall frame
Flush with
Floor Framing
1/2” overhang
Important -
Make sure all walls are aligned
in their upright position. If not, water may
leak into your shed. Unsure if panel is
facing up or down? Compare solid wall
siding to window wall siding and match
orientation.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 12
