Olsberg Orayonne, Инструкция по эксплуатации

Страница: 22 / 88

22
Installation instructions for the fitter
Important information
•
Olsberg glass radiation heater conform to all relevant safety standards and regulations.
•
They must be installed and commissioned by an authorised fitter and with due regard to the
relevant safety instructions. All repair and maintenance work must also be carried out by an
authorised fitter.
•
Always strictly adhere to the local safety instructions .
•
Local safety requirements must be observed.
•
The appliance is designed for wall installation (vertical or horizontal) or for mounting on the
ceiling (at a distance of > 180cm from the floor). For floor mounting, use glass panel holders
(see chapter "Accessories").
•
When mounted on a wall, the appliance is classified in protection rating IP24. When mounted
on the ceiling, the appliance is classified in protection rating IP20.
•
For the installation of the appliance in bathrooms, ensure that the safety zones according to
DIN VDE 0100, part 701 are observed.
•
Always maintain the specified minimum distances.
•
Do not remove the foam bloc (Fig.1, item 6) at the rear side of the appliance! The block is not
part of the packaging but keeps the device at a safe distance from the wall.
Installation
Location of installation
In order to make best use of the heat radiation effect, the appliance should be installed as close as
possible to the person to be heated. The further away one stands from the appliance surface, the
smaller is the sensible heat. Distances of between 1 and 3 m have been proven ideal.
When installation on the wall (see
Fig.4), the appliance meets the
requirements of protection rating IP24.
This means that the heater can be
installed in zone 2 of bathrooms (see
Fig.3). If necessary, the authorised
fitter must upgrade the site connection
to protection rating IP24. When
installing the appliance in a bathroom,
ensure that external switches or
control elements of the room
thermostat cannot be reached by a
person sitting or standing in the
bathtub or the shower.
Fig.3
When installed on the ceiling (see
Fig.5), the appliance meets the
requirements of protection rating IP20,
which means that it must be installed
outside zone 2 (see Fig.3).
Fig.4 Fig.5
IP24 IP20
Dimensions in cm
Zone
Zone Zone
Zone
Zone Zone
Zone 1
a) Side view b) Top view