Olsberg Orayonne, Инструкция по эксплуатации

Страница: 34 / 88

34
Mounting glass radiation heater on the wall bracket (see chapter "Electrical connection).
Caution: The heater must be mounted on the wall bracket without rear panel hiders. The hiders must
also first be removed before the heater can be detached from the bracket.
The rear panel hiders are supplied with two M4x35 screws serving as mounting handles only. Insert
these screws by a few millimetres into the rear panel hider to be mounted first (see figure 9).
Fig.10: Detail „Top view“
1
Hold the hider by the screws and
align it so that the side with the
magnets faces the rear panel of the
heater and the rectangular open-
ings of the hider are at the same
height as the sleeves at the rear
panel of the heater. Slide the hider
along the wall to the stop at the
rear of the heater.
2
Pull the hider towards
the rear panel of the
heater until the mag-
nets are attached.
3
Push the hider further
to the second stop.
When the hider is properly positioned, remove the screws (mounting handles) and repeat the above
steps with the next hider. The screw holes in the rear panel hiders can subsequently be concealed with
the supplied dummy plugs.
To dismantle the rear panel hiders, complete the above steps in reverse order.
1
1 3
2
M4x35 screw
(mounting handles)
Magnet
Rectangular
opening
Rear panel hider
Fig.9