Olivetti S2, Руководство пользователя, Страница: 7 / 63

589402 User Manual vii

The heated parts must be left to cool for a certain length of time at the end of the printing process or
when printing is interrupted: leave the machine to cool (for approx. 5 minutes) before attempting to
access the printing area. It is good practice to check that the machine temperature shown on the front
display (of the printhead and table) is under 40°C before carrying out any intervention.
Do not touch
the printhead as it could be very hot after use.

Do not wear rings, wristwatches, jewellery or loose/baggy clothes such as scarves, unbuttoned jackets,
tops with open zips that could become entangled in the moving parts. Keep hair tied back.

Do not insert your hands between the parts in movement.

Do not use the printer for a different purpose from that for which it has been designed, as specified in
the User Manual.

Do not attempt to clean the printer while is in operation. Clean the outside of the device with a soft cloth
only without using corrosive chemical products, solvents or strong detergents, and only after having
disconnected the device from all external power supplies and other cables.

It is recommended that the printer not be left unsupervised during printing

Make sure that the room where the printer is installed is well ventilated.

Do not leave objects or scrap inside the printer (such as lacquer, rags, wrenches used for maintenance,
materials removed,..) before launching a printing job.
The printer is equipped with a pressure-sensitive mat that activates if it encounters an obstacle
while the heated table is descending towards the bottom of the unit, causing the operation of the
machine to be interrupted
. After removing the obstacle, you can put the machine back into operation
by pressing the special reset button on the right side of the printer.

You must exercise the greatest care when removing the worked piece from the glass table using sharp
or pointed objects to avoid injuring yourself. The use of knives or cutters for removing worked pieces
from the glass table is strongly discouraged, even in the case of small objects. Although the glass is
tempered it is also fragile, so you must be very careful when handling it.

Remove the piece from the glass only after having waited the cooling time necessary (when the heated
table has been used);

If required, clean or change the printing nozzle. The extruder must be hot to allow the residual material
inside the head to soften and not create an obstruction during replacement : operate always wearing
heat protection gloves.