Olivetti S2, Руководство пользователя, Страница: 22 / 63

2-4 User Manual 589402
Figure 2-5 Adjusting nut positions
5. After the first adjustment is complete, press the jog dialer again. The extruder assembly moves to the
second adjustment position.
6. Now repeat the adjustment as described at point 4 , and press the jog dialer to bring the extruder assembly
to the next adjustment position.
7. The total number of adjustment positions is 5 and, for each of these, the adjustment must be carried out as
described at point
4 .
8. After completing the adjustments, the extruder assembly returns to the Home position and the display
returns to normal.
NOTE: Normally the first layer printed is deposited with a greater thickness than the following layers
(setting the Slicing software appropriately). This expedient can compensate for any small
misalignments.
NOTE: the flatness of the tempered glass cannot be guaranteed with centesimal accuracy therefore
the first layer of the material printed may not be laid uniformly; consequently it is essential to ensure
that the external lines are uniform in order to ensure good adhesion.
The centesimal differences in height are compensated in the next 2-3 layers.
WARNING: Incorrectly executed height adjustment operations may result in bad printing quality or, in
the worst case, a collision between the hot end and the printing table, causing damage to the machine.
Adjusting nuts
Adjusting nuts