Olivetti S2, Руководство пользователя, Страница: 37 / 63

589402 User Manual 3-1
Chapter 3 – USING AND PRINTING WITH THE OLIVETTI S2 PRINTER
USING AND PRINTING WITH THE OLIVETTI S2 PRINTER
After having adjusted the printer and loaded the bobbin containing the filament, the printer is ready for use.
WARNING: if machine operation has been interrupted, for example due to use of the emergency push-
button, or the presence of an obstruction under the heated table, printing must be started again from
the beginning.
To unblock the emergency push-button on the right side of the printer, it must be rotated in a clockwise direction.
If the block occurs because an obstruction is present under the heated table, remove it then put the machine
back into operation by pressing the reset button on the right side of the printer.
Printing a test piece
On the SD card provided in the package, there is a file that can be used for executing a test print job and allowing you
to gain confidence using the printer.
WARNING: if there is difficulty recognising/reading the SD Card, check the position of the lock slider
on the side of the card. The slider must be set to the unlocked position (so as to enable both reading
and writing).
To print the test piece:
1. Insert the SD CARD supplied in the package into the slot on the front of the printer
2. Select the SD Card menu to access the file manager.
3. Select the file to print (Logoolivetti1.gcode) by turning the jog dialer and then pressing it to confirm.
4. The machine now starts the automatic printing procedures reading the GCODE indicated and executing all
the phases. You can follow the process from the info menu and, of course, through the transparent windows
of the machine.
When the print job is run, the printer executes the following procedures:
1. Homing of all axes,
2. Heating of hot-end and of table (if required) until the requested temperature is reached
3. Extrusion of a part of the material for loading into the extrusion chamber
4. Movement in the printing zone, starting procedure for printing layer on layer.
5. On completion of the printing process, the machine sends the carriage to the Home position and switches
off the heaters to allow the machine to return to normal environmental temperature.