Olivetti S2, Руководство пользователя, Страница: 6 / 63

vi User Manual 589402
TRANSPORTATION AND INSTALLATION:
Lifting equipment must be used for transporting the 3D printer (such as a fork lift truck ) together with belts. Make
sure that the vehicle used for transportation and the lifting equipment are strong enough to withstand the weight
of the printer and its packaging (approx. 120 Kg).
Personnel charged with handling the shipment must wear safety gloves.
When lifting or moving the 3D printer, or any of its parts, first make sure that the operating area is completely
clear, leaving also a sufficiently large safety area around it to avoid damaging persons or objects that could come
within the area for manoeuvring the load.
It is recommended that you use specialised personnel for the installation and following the instructions below:

the printer must be placed on a surface (not supplied with the printer) able to support its weight which is
stable, level and at a minimum height of 60 cm.

the electronic parts are ventilated using fans. Make sure that there is sufficient free space around the printer
to allow sufficient air to circulate for ventilation purposes. You should leave a distance of at least 60 cm from
walls and other objects.

do not position the printer near sources of heat, water or other freely moving liquids.

do not expose the device to dust, rain, humidity or vapour.

the temperature of the working environment should be maintained at around 20°C.

by law the equipment must be grounded; use exclusively the power cord provided in the supply without
extension cords.

to protect the printer during transportation, the printing carriage is locked into position by bands: before
starting printing cut and remove these bands.
USE

The S2 printer is not suitable for use by persons under the age of 14 years, and always under the direct
supervision of an adult. Make sure that children do not tamper or play with the equipment.

The printer is intended for use by operators with adequate training.

Use the power supply voltage specified in the technical specifications. The power cord must never pulled,
loaded with weights or brought into contact with sharp parts.

Do not touch the equipment with body parts that are wet and always wear footwear.

Do not smoke, use naked flames or create sparks near the printer.

In the case of printer failure or malfunctioning, do not attempt to use it again until it has been repaired.

In the case of an emergency, press the red coloured emergency stop button found on the right side of the
printer.

When the S2 printer is functioning, certain parts generate high temperatures (printhead, heated table); there
are also moving parts which can cause injury if touched accidentally during operation. You must therefore
observe carefully the following warnings:

Whenever any operation is carried out on the printer - whether for installation or maintenance purposes
- always switch off and disconnect the equipment from the electrical socket. Also wait for all parts that
may have become heated during the preceding operation to cool down.

The machine must be used exclusively with the front door closed ; the printing process IS NOT
interrupted automatically when the door is opened, therefore this rule must be observed with maximum
attention.

The front door is fitted with a lock and key to prevent unauthorised access.

The key of the lock must be kept safe by those assigned responsibility for it.