Olivetti JET-LAB 500, Инструкция по эксплуатации

Страница: 61 / 83

49
7
Call the fax machine
with the required
pattern so that it will
accept it. The message
"RING DETECTED"
should be displayed.
8 Press the STOP key to
restore the fax machine
to the initial waiting
mode.
PHONE/FAX RX
19-03-99 12:55
If the fax machine does not succeed in accepting this
specific pattern, the message "RING NOT DETECT."
is displayed. At this point press the STOP key and
repeat the procedure from the beginning.
Changing the beeper duration ...
This feature is anabled only in some countries.
When the fax machine is set to automatic reception
with call type recognition, it behaves as follows:
• If a fax is calling, it will receive automatically after the
set number of rings
• If a telephone device is calling, it will beep for 20
seconds, after which, if you still have not lifted up the
receiver, it will receive automatically.
You can change the beeper duration as follows:
Procedure DISPLAY
1 Make sure that the
display shows the initial
waiting mode with date
and time.
PHONE/FAX RX
30-03-99 12:55
2 Press the FUNCTION
key until the display
shows --->.
INSTALLATION
3 Press the START key.
TEL. LINE SET-UP
4 Press the START key
until the display shows
--->.
FAX/TEL TIMER: 20
5 Press the </> keys to
show the other values
available: "15", "30" e
"40". (In the example:
"15").
FAX/TEL TIMER: 15
6 Press the START key
to confirm your
selection, then the
STOP key to restore
the fax to the initial
waiting mode.
PHONE/FAX RX
30-03-99 12:55
Changing the silence lapse ...
This feature is enabled only in some countries.
Remember that if the silence lapse set on the exter-
nal answering machine is inferior to that set on your
fax, the latter will never be able to function automatically
in reception as the answering machine starts operating
first and as the fax does not hear any answering mes-
sage, within the set time lapse, it interrupts the connec-
tion.
You must decrease the value of the silence lapse on
your fax so that it can connect to the line first.
To change the silence lapse value on your fax, proceed
as follows:
Procedure DISPLAY
1 Make sure that the
display shows the initial
waiting mode with date
and time.
TAD/FAX RX
30-03-99 12:55
2 Press the FUNCTION
key until the display
shows --->.
INSTALLATION
3 Press the START key. TEL. LINE SET-UP
4 Press the START key
until the display shows
--->.
SILENCE LAPSE: 6
5 Press the </> keys to
show the other values
available: "3", "4", "8",
"10" and "NO". (In the
example: "4").
SILENCE LAPSE: 4
6 Press the START key
to confirm your
selection, then the
STOP key to restore
the fax to the initial
waiting mode.
TAD/FAX RX
30-03-99 12:55
-7-46-54.p65 02/04/01, 9.22 49