Oliver APF0038, Руководство пользователя

Страница: 12 / 20

- 12 -
APF0038-48
E D F
POWER CONNECTION
AND GROUNDING
(FIG. 12, 13 & 14)
WARNING: Make sure
electric currency matches the
motor specification (see
motor cover.)
WARNING: Make sure
switch is on the “OFF”
position
.
A) CE REQUIRED COUNTRY:

Feeder is a supplemental
tool, which works in conjunction
with your shaper, table saw,
jointer, … etc. It’s
recommended to be used with
a machine that is wired in
compliance with your national
or local electrical regulation.

It must be connected to your
machine through a specially
designed current taps that
ensures your machine’s switch
and emergency stop having
controls of your feeder’s power
source. In addition, the current
tap must provides an overload
and under voltage protection
systems.

Rated Current List

Electrical connection is
reserved for certified electrician
only.
B) OTHER’S COUNTRY:

A separate electrical outlet
should be used for your feeder.
The circuit should not be less
than # 12. Wire properly
installed and grounded in
accordance with your local
codes and ordinances,
protected with a 15 Amp time
lag fuse or circuit breaker.

If an extension cord is used,
≦
30M (100Ft), use #12 Wire;
≧
46M (150Ft), use #10 Wire.

Ensure all line connections
make good contact. Low
voltage running will damage the
motor.

Properly ground the motor to
reduce the risk of electrical
shock.

The motor is equipped with a
grounding conductor (green
wire with or without yellow
stripes.)

If unsure, consult with a
qualified electrician.
Model 32 308/408 34/44/38/48/04/54/C3/MX 30/40
Current 1.5A 2A 2.5A 3A