Oliver 619-16A, Руководство пользователя по эксплуатации и инструкция

Страница: 14 / 38

0619S20049 4-4
Replacing The Hydraulic Cylinder
•
Using the cleaning separator extend the knives about half of their travel. Turn the
machine off and disconnect it from the power supply.
•
To remove the hydraulic cylinder the front, rear, and side panels must be removed
from the machine.
•
Place blocks of wood between the thrust plate and the cylinder-mounting channel to
secure it during cylinder removal.
•
Remove one of the center plastic floor assemblies, (see above procedures). Once
this has been done the bolt securing the thrust plate to the cylinder rod can be
removed using a universal socket style wrench.
•
Remove the four screws securing the star plate to the outer cylinder rod.
•
Remove the bolts securing both the main starter switch bracket and the limit switch
bracket to the hex support rods. DO NOT disconnect the wires.
•
Remove one of the snap rings securing the yoke’s pivot pin. Remove the pin so that
the linkage can be unhooked from the top of the machine.
•
Remove the eight screws securing the cylinder to the cylinder-mounting channel.
•
Remove the four bolts securing the cylinder-mounting channel to the lower hex
support rods.
•
The upper portion of the divider can now be removed and set to one side.
•
Disconnect the high-pressure hose and lower tube assembly at the cylinder allowing
removal of the cylinder for repair or replacement.
•
When the machine is reassembled the bolt securing the thrust plate to the cylinder
rod should be installed using “Loctite” thread locker #242 to prevent loosening during
operation. All other components can be reinstalled by reversing the above steps.
Removing The Motor
•
Remove the front, rear and “Motor Side” panels.
•
Remove the four screws securing the pump bracket to the front of the motor.
•
Remove the four screws securing the motor to the shock mounts.
Continued